Add a Data Gateway

Procedure

1. In the navigation pane, select O&M Management > Migration Resources > Data Gateway.
2. On the Data Gateway page, click Add Data Gateway.
3. In the Add Data Gateway dialog, configure the following options:

   Option	Description
   Name	Set a name for the data gateway.

   Configure resources and networking for the gateway VM:

   Option	Description
   Data Center	Select the data center where the VM resides.
   Location	Select where the VM runs.
   CPU	The default is 8 cores. Set the number of CPU cores.
   Memory	The default is 8 GB. Set the memory size.
   Storage Location	Specify the data storage.
   Storage Pool	Select a storage pool when the storage location is Ceph distributed storage.
   Disk 1	The default is 100 GB. Set the system disk size.
   Network	Specify a distributed port group. Ensure that the selected distributed port group has network connectivity with both the source and target platforms to support data transfer.
   IPv4 Address	Specify an IP address. Note: The IP address allocation method depends on the configuration of the selected migration network: When DHCP is enabled on the migration network, the system automatically assigns an IP address. When DHCP is not enabled on the migration network, you must manually specify an IP address. When IP address management is enabled on the migration network, if you manually specify an IP address, ensure that the address is within the selected network segment.
   Subnet Mask and IPv4 Gateway	If DHCP is disabled on the network, enter the subnet mask and IPv4 gateway for the gateway VM.

4. Review the configuration and click OK.